![]() When troubleshooting for this issue, you need to check first if the battery is charging. This drain is not caused by the alternator but rather by other components in the forklift’s electrical system. If there is a parasitic drain, the circuit voltage can drop to a very low point. The parasitic drain could trigger a state of low charge of the battery. ![]() If you suspect that there is a parasitic drain This issue also causes overcharging because the regulators cannot read the level of electricity and as an outcome, it will overcharge the battery. If you think that it is the rotors or the regulators that cause overcharging, you may have failed ones. This overcharging initiate damage to the battery and this concern can get out of control if your forklift’s battery is old. If your truck’s battery is old, it causes the alternator to work extra hard in order to produce enough charge. The cause of overcharging can easily be pinpointed: it is either poor battery condition or failed regulators. If the alternator would test good and in good working condition, but still the alternator would not charge, see if the fuse links and connection were bad, in many cases this simple check does solve the problem.Īfter testing and you found out that the alternator overcharges, the battery may warm up that could cause damage to its interior components. Corrosion in the battery terminals and minute resistance in the ground circuit can significantly disrupt the charging output. The condition of the belt should be checked on a regular basis.īad cables and terminals could also cause the alternator not to charge. The tension of the belt could also cause the problem, check if the belt has the right tension. If the belt installed is slipping, it will cause the alternator not to charge or to undercharge. Some other problems that cause the alternator not to charge are the conditions of the belt and pulley. This determines if the charging system is not working properly and that the alternator is not able to produce sufficient charge for the battery. If you suspect that the alternator doesn’t charge the battery, check the battery state of charge and voltage regulation. Troubleshooting the Alternator to Determine If It Is the Cause of the Problem Before Replacingīefore making the judgment if it is the alternator that’s causing the problem, isolate other side troubles in the charging system that may have affected the performance of the alternator such as the connector, battery, cables, or internal circuit. If your instinct tells you that the alternator is the culprit, make sure to test it first by pinpointing if it is the real cause of the problem, this will prevent you from spending on an unnecessary repair. These are the tell-tale signs of trouble with the alternator you need to take note of. If you smell burning rubber, it is important to have the alternator checked by the mechanic right away. The conspicuous clues you would notice that there is an advancing fault can include flickering gauges, dimming lights and noticeable whining sounds coming from the engine.Ī failing alternator doesn’t get the battery recharged and thus cause the engine not to start. Identifying the early signs can warn you to have the alternator checked immediately before it becomes a big difficulty. The alternator can last a long time but if your truck is old, it is inevitable that this can become faulty. The alternator produces power for the other components of the forklift truck such as the lighting, gauges and the instrument panel. ![]() The alternator together with the battery and voltage regulator form part of the forklift's charging system. When Replacing Forklift Alternator: Know These First
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |